Descargar Imprimir esta página

HOMCOM 853-016 Serie Manual Del Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

7. The water tank is placed on the main engine as shown in Figure 9.
Figure 9
Figure 10
3. Ironing methods
a) Grab the lower part of the garment by hand and pull it down. Pay attention to
make the surface of garment as flat as possible.
b) Press down gently with the steam jet, then drag the jet up and down and set it
through tension after softening the fiber with high-temperature steam line.
c) Grab both sides of the clothes and tighten it when the bottom of the clothes is
ironed. Iron up and down and be careful with the hot steam from the steam jet.
d) When ironing the collar, press it down slightly. It will take a longer time for the
steam jet to be pressed on the lapel of the collar to iron up and down.
e) When ironing on the sleeves of the clothes, the sleeves shall be straightened
slightly. When the steam jet presses the lapel of the sleeves, it also takes a longer
time to iron back and forth.
f) Iron the back after ironing the front.
g) Turn off the power after ironing.
IV. Cleaning and storage
Usual cleaning and storage
1. Turn off the power switch and unplug the power line.
2. Wait until the machine is completely cooled (at least 30 minutes).
3. Take out the water tank, unscrew the knob of the water tank, pour out the water in
the water tank, then clean it with water and pour the water completely. Put the water
tank back into the water storage tank.
4. Unscrew the drainage (boiler cleaning) knob at the bottom of the host by turning
over, keep the water in the host flat and then tighten the drainage (boiler cleaning)
knob.
5. Place the unit in a dry place.
Boiler wall cleaning
1. Put about 50ML of white vinegar from the outlet of the machine first.
2. Add appropriate amount of water, put the kettle on the machine, plug in the power
supply, and work for about 30 minutes.
3. After working for about 30 minutes, turn off the power supply, remove the plug,
and pour out the dirt in the heater from the air outlet.
4. Then pour appropriate amount of clean water from the top air outlet, lift the
machine, shake it from left to right a few times, and then pour the water out from the
air outlet. Repeat several times in turn.
Warning: to clean the dirt on the inner wall of the boiler, you have to use the
professional cleaning agent (cleaning agent containing glycolic acid, vinegar and
baking soda) for the air conditioner and the inner wall pipe of the heater.
Do not use the cleaning agent containing acid and hydrochloric acid.
Note: be careful to prevent the danger of steam splashing when using appliances.
When filling the liquid and cleaning, unplug the power plug If the power line is
damaged, it should be replaced by a professional to avoid danger
U K = q ì ê å = í Ü É = â å ç Ä = í ç = á å Ç á î á Ç ì ~ ä = å É É Ç = Ñ ì å Å í á ç å I = ë ï á í Å Ü = ä á Ö Ü í = á ë = Ä ê á Ö Ü í K = f í = á å Ç á Å ~ í É ë = í Ü ~ í = í Ü É = ã ~ Å Ü á å É = á ë = ï ç ê â á å Ö = é ê ç é É ê ä ó K = Q P = ë É Å ç å Ç ë = ä ~ í É ê I = í Ü É = ë í É ~ ã = Ü ç ë É = ë é ê ~ ó = ë í É ~ ã I = ó ç ì = Å ~ å = á ê ç å = Å ä ç í Ü É ë I = ~ ë = á å = c á Ö ì ê É = N M K
4

Publicidad

loading

Este manual también es adecuado para:

853-016v90