Bpt GW 90 740A Manual página 15

The actuator is configured with the ETS software to create the functions listed below.
Switchover:
- parameterisation of output behaviour (NO/NC)
- timing of stair lights and the possibility of setting its duration via the BUS
- timing of stair lights with switch-off warning function
- delayed activation/deactivation
- blinking
Scenes:
- memorisation and activation of 8 scenes (value 0 - 63) for each output
- enabling/disabling storing of scenes by the BUS
Priority commands:
- parameterisation of the output relay value at the end of forcing
Blocking command:
- parameterisation of the blocking object value and output relay value at the end of
blocking
Safety functions:
- periodical monitoring of input object
Logical functions:
- AND/NAND/OR/NOR logical operation with command object (switchover, timed
switchover, delayed switchover, blinking) and result of the logical operation
- using the result of the logical operation to enable the command object (switchover,
timed switchover, delayed switchover, blinking, scene)
- logic operations AND/NAND/OR/NOR/XOR/XNOR up to 4 logic inputs
Output status:
- parameterisable sending to the BUS
Other functions:
- parameterisation of output behaviour with voltage fall/reset on BUS
- parameterisation of behaviour of local command push-buttons
GENERAL DESCRIPTION
Functions
15
E
N
G
L
I
S
H