urmet domus 1092/003 Manual De Instrucciones página 9

AUTO-IRIS PLUG
Auto-Iris plug PIN definition
PIN VIDEO
DC 12v
1
NC
2
IRIS DRIVER (+)
3
GND
4
AUTO-IRIS LENS FOCUSING PROCEDURE
1. Fit the optics on the camera.
2. Position the VIDEO/DC switch according to the lens employed.
3. Connect the wire to the Auto-Iris connector.
4. Position the AGC switch to NOR.
5. Turn the LEVEL trimmer to H until the picture is white.
6. Position the ES switch to ES: the picture appears out of focus.
7. Adjust the focus.
8. Position the ES switch to NOR: the picture can be white.
9. Turn the LEVEL trimmer to L until the picture appears well lit.
10. Position the AGC switch to AGC.
11. Turn the back-focus adjustment ring and repeat the operation from point 4 if focus is not correct.
DS1092-003
1
DC
DAMP (-)
DAMP (+)
DRIVER (-)
2
IMPORTANT:
consumption of 50 mA.
Urmet series 1090 AUTO-IRIS DC DRIVER lenses may
3
be directly connected to the camera.
Shift the wire from pin 2 to pin 3 on the lens
connector if a Urmet Domus 1090 AUTO-IRIS VIDEO
DRIVER lens is used.
4
Lenses must have a maximum
9