Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the
Glass Shades
REMEMBER to make sure the power is off
before attaching or removing the glass shades.
1. Insert the glass shade into the glass holder
by carefully squeezing the steel tension-
ers on the light fixture socket together
(Figure 17).
2. Gently slide the glass shade over the steel
tensioners. Make sure the glass shade is
fully inserted into the socket for a secure fit.
Repeat for the remaining glass shades.
3. With the power off, insert the light bulbs
(included) into the light kit sockets.
Max 14W.
4. Repeat steps 1, 2 and 3 for the remaining
glass shades.
Blade Balancing
All blades are grouped by weight. Because
natural woods vary in density, the fan may
wobble even though the blades are weight
matched. The following procedure should
correct most fan wobble. Check after each
step.
Check that all blade and blade bracket
1.
screws are secure.
Most fan wobble problems are caused
2.
when blade levels are unequal. Check
this level by selecting a point on the ceil-
ing above the tip of one of the blades.
Measure from a point on the center
of each blade to the point on the ceil-
ing. Measure this distance as shown in
Figure 18. Rotate the fan until the next
blade is postioned for measurement.
Repeat for each blade. Measurement
deviations should within 1/8". Run the
fan for 10 minutes.
Use the enclosed Blade Balancing Kit if
3.
the blade wobble is still noticeable.
Figure 17
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
Figure 18
9.
Publicidad
