Publicidad
Idiomas disponibles
Idiomas disponibles
To reduce the risk of electric shock, insure electricity
1.
has been turned off at the circuit breaker or fuse box
before beginning.
All wiring must be in accordance with the National
2.
Electrical Code (ANSI/NFPA 70-1999) and local electri-
cal codes. Electrical installation should be performed by a
qualified licensed electrician.
WARNING: To reduce the risk of fire or electric shock, do not
3.
use this fan with any solid-state fan speed control device.
WARNING: To reduce the risk of fire, electrical shock, or
4.
personal injury, mount fan to an electrical box marked "ac-
ceptable for fan support" and use the mounting screws pro-
vided with the electrical box.
The electrical box and support structure must be securely
5.
mounted and capable of reliably supporting a minimum of
35 pounds. Use only UL Listed electrical boxes marked
"FOR FAN SUPPORT."
The fan must be mounted with a minimum of 7 feet
6.
clearance from the trailing edge of the blades to the floor.
Do not operate reversing switch while fan blades are in mo-
7.
tion. Fan must be turned off and blades stopped before re-
versing blade direction.
Avoid placing objects in path of the blades.
8.
To avoid personal injury or damage to the fan and
9.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL
INJURY, MOUNT FAN TO ELECTRICAL BOX MARKED ACCEPTABLE
FOR FAN SUPPORT WITH THE SCREWS PROVIDED WITH THE ELEC-
TRICAL BOX.
READ AND SAVE THESE INSTRUCTIONS
other items, be cautious when working around or
cleaning the fan.
Do not use water or detergents when cleaning the fan or fan
10.
blades. A dry dust cloth or lightly dampened cloth will be
suitable for most cleaning.
After making electrical connections, spliced conductors
11.
should be turned upward and pushed carefully up into
electrical box. The wires should be spread apart with
the grounded conductor and the equipment-grounding
conductor on one side of the electrical box.
Electrical diagrams are for reference only. Light kits that are
12.
not packed with the fan must be UL Listed and marked suit-
able for use with the model fan you are installing. Switches
must be UL General Use Switches. Refer to the instructions
packaged with the light kits and switches for proper assembly.
Use 14W CFL BULBS (included).
All set screws must be checked and retightened where neces-
13.
sary before installation.
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS ("FLANGES") DURING
ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT OBJECTS IN
THE PATH OF THE BLADES.
PLEASE REMOVE RUBBER MOTOR STOPS ON THE BOTTOM OF THE
FAN BEFORE INSTALLING BLADES OR TESTING MOTOR.
TO REDUCE THE RISK OF SHOCK, THIS FAN MUST BE INSTALLED
WITH AN ISOLATION WALL CONTROL/SWITCH.
Safety Rules 1.
Publicidad
