Descargar Imprimir esta página

Powerplus POWDP25230 Traduccion Del Manual De Instrucciones Originale página 41

Sierra circular 185mm 40 v (sin batería)

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
− In case of skin or eye contact, follow the instructions below:
Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2
Chargers
Use the charger provided with the tool only to charge the battery
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
8
CHARGING AND INSERTION OR REMOVAL OF BATTERY
8.1
Charger indications (Fig. 1)
Connect the charger to the power outlet socket
Solid green: ready to charge
Flickering red: charging
Solid green: charged
Solid green and red: battery or charger damaged
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1.
Frequently monitor the charger and battery pack while connected
2.
Unplug the charger and disconnect it from the battery pack when finished.
3.
Allow the battery pack to cool completely before using it.
4.
Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
8.2
Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the tool is switched off
or remove the battery pack.
Hold the tool with one hand and the battery pack (20) with the other.
To install: push and slide battery pack into battery port, make sure the release latch (21)
on the rear side of the battery snaps into place and battery is secure before beginning
operation.
Copyright © 2022 VARO
POWDP25230
P a g e
| 8
EN
www.varo.com

Publicidad

loading