Additional safety rules:
1. Wear a hard hat (safety helmet), safety glasses and /or face shield. It is also highly recommended that you wear a dust
mask, ear protectors and thickly padded gloves.
2、 Be sure the bit is secured in place before operation.
3. Under normal operation, the machine is designed to produce vibration, the screws and bolts can come loose, causing a
breakdown and accidents. Check tightness of them carefully before running.
4. In cold weather or a long time tool not be used, please keep the tool running without load a few minutes to warm up the
grease inside, otherwise hammering function is difficult to get.
5. Be sure you stand stably and no one is below when you using tool is in high location.
6. Hold the tool firmly with two hands.
7. Don't touch any moving parts.
8. Don't leave the tool running itself, operate tool only when hand-held.
9. Don't point the tool to anybody for the bit could fly out in case.
10. When chipping into walls, floors or wherever "live" electrical wire may be encountered, DON'T TOUCH ANY METAL
PARTS OF THE TOOL! Hold the tool by the insulated grasping surface to prevent electric shock if you chip into a "live"
wire.
11. Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may extremely hot and could burn
your skin.
12. Any damage and abnormal happen, please stop to use immediately and disconnect it, ask authorized serve center to
check and repair.
13. Parts replace: Only original
can be used to replace by authorized service center.
14. Right use accessories and parts: Don't use other parts and accessories which not mentioned in the manual otherwise
may cause injuries!
15. Special attention to voltage: Before connect the power tool, please make sure the rated voltage on the tool can match
the power supply, otherwise the power tool may be damaged and cause injuries.
16. Don't wipe plastic part with solvent: Solvent such as gasoline, thinner, alcohol etc. these kind of chemical material, are
not allowed to use, water or soap are recommended!
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Keep Working
06
01
D H
7 5 3 1