Behringer ULTRA-DI DI400P Manual Del Usuario página 21

1. Control Elements and Connections
(1)
(2)
Fig. 1: Top view
PARALLEL IN/OUT (¼" TS): These connectors are
+
(1) (2)
used for connecting unbalanced signal sources. Because both
connectors are wired in parallel, they can be used both as an
input and as a direct output to loop the signal through to a
monitor amplifier.
OUTPUT (XLR): This is the balanced mic-level output.
(3)
Use a high-quality balanced microphone cable to establish
connection.
Using the GND LIFT (ground lift) switch, you can fully
(4)
separate input and output grounding. Depending on how the
equipment to which your DI400P is connected is grounded,
using the GND LIFT switch lets you lower hum noise or
ground loops. When the GND LIFT switch is in LIFT position,
the ground connection is interrupted.
The SERIAL NUMBER of the DI400P is located at the bottom.
21
User Manual
(4)
(3)