6. After you install the two brackets, you just need to let the two bolts on the brackets pass through the
two holes on the wall mount, and then screw in the two nuts. The side which the power cord go in is the
bottom, make sure the top is up and bottom is down, never install the barber pole upside down.
3.3.
Device use
Connect the unit to a suitable power source.
Press the switches on the power cord so that the unit lights up and starts to rotate. One switch controls
the light and the other controls the rotation.
Press the switches to switch the unit off and remember to disconnect the plug after use.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
•
Wait for the rotating elements to stop.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Do not allow water to get inside the device through vents in the housing of the device.
g)
Clean the vents with a brush and compressed air.
h)
The device must be regularly inspected to check its technical efficiency and spot any damage.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
k)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
DISPOSING OF USED DEVICES:
EN
1 – Top
2 - Bottom