Measuring - Irwin EM50 Instrucciones De Funcionamiento

Setting for measure reference.
Setting the unit for distance measurements

Measuring

Single distance measurement
Laser continuous
Press this botton to change the reference of instrument.
In the display will show:
For measurements from the front of instrument:
For measurements from the rear of instrument:
Press and hold to switch the unit to the measurement you need,
The following units are available: m(meter), ft(feet), in(inch),ft+/
in(feet-inch-1/16).
Press to activate the laser.
Press again to trigger the distance measurement. The result is dis-
played immediately.
Press and hold down the key when switching on the
device until the character appears permanently in the
display. Every further press of the key releases a
distance measurement. Press the key and hold to
switch the device and laser continuous operation off.
English | 39