Difrax C631 Manual Del Usuario página 26

MAINTAINING FOOD TEMPERATURE MODES (bottle or dinner mode)
Place the warmer on a flat and stable surface, out of the reach of children, where it can't be knocked or moved
1.
during use. If you have any doubts, read the warnings at the beginning of the instructions again.
Add about 200 ml of water to the empty heating chamber.
2.
Place the bottle(incl. teat, excl. cap)/jar basket(excl. cap) in the heating chamber.
3.
Place the bottle prepared for feeding or an open container in the basket. Place the bottle/jar as accurately as
4.
possible in the middle of the warmer to ensure even heating.
Plug the warmer into the power socket. All icons on the display will appear and then disappear. This means that the
5.
warmer is receiving mains power.
Press the button
6.
warmer when there is no water in it.
Press the function button,
7.
Maintaining the temperature of water for formula milk – "Bottle":
The temperature is pre-set to 40˚C. You can change the pre-set temperature in the range: 35˚C - 50˚C, depending on
•
your needs, by using the "-" and "+" buttons on the control panel.
After setting the temperature, the warmer will start working at the set value, counting down the operating time
•
starting from 10 hours.
During this time, the temperature of the water in the warmer will be maintained at the indicated level.
•
After 10 hours, the appliance will automatically end the cycle, signalling it with a "Dee-Dee-Dee" sound.
•
Bottles with removable bottom ring are not suitable for keeping warm for long periods of time, it can cause
•
leakage.
Maintaining temperature of solid foods – "Dinner":
The temperature is pre-set to 70˚C. You can change the pre-set temperature in the range: 50˚C - 90˚C, depending on
•
your needs, by using the "-" and "+" buttons on the control panel.
After setting the temperature, the warmer will start working at the set value, counting down the operating time
•
starting from 3 hours.
During this time, the temperature of the water in the warmer will be maintained at the indicated level.
•
After 3 hours, the appliance will automatically end the cycle, signalling it with a "Dee-Dee-Dee" sound.
•
For the safety of your children, always check the temperature of the food before feeding. Place a small amount
of the food on the inner part of your wrist - as the skin is delicate and sensitive at this spot.
To stop the warmer during the cycle, press the button
8.
power supply.
, and the display will show "00", meaning standby mode. Remember! Never switch on the
selecting the bottle mode or dinner mode
to turn off the warmer, and then disconnect it from the
24
: