Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 Safety instructions
ELECTRICAL DANGER
Risk linked to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• The device must be properly connected and comply with current regulations.
WARNING
When operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use spare parts that are not original.
ELECTRICAL DANGER
Risk linked to electric current!
If incorrectly installed, the device may be dangerous and cause injury. Before any installation, check the
electrical network data. Plug in the device only when it complies. The device must be unpacked and checked
completely before connection by a professional.
5.2 Use
WARNING
The installation of the device and maintenance should only be carried out by professionals.
• Do not leave the device running without monitoring it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
1. LED screen
2. Sensor
3. Air outlet
4. Side window
5. Switch
6. Thermal switch
7. Lighting screen
8. Shell
9. Tray fig.1
The hand dryer must be grounded in accordance with local regulations. Failure to properly ground the unit
could result in serious electric shock and/or death. The hand dryer must be isolated from the power supply
during installation and maintenance.
Note :A double-pole switch must be installed between the hand dryer and the power cable (see external wiring diagram).
Terminal gauge should be greater than 3mm
1. Turn off the power supply and ensure that it cannot be turned back on until the installation is complete.
2. Place the template against the wall at the desired height (see RECOMMENDED MOUNTING HEIGHTS) and
mark the locations of the 5 mounting holes and entry of the power cord at the cut-out location (see fig.3).
External wiring diagram
EN
Publicidad
