Mark MKL 144 IP WR Manual Del Usuario página 7

5 Blue dimmer
6 White dimmer
7 Mode
8 Speed mode
CAUTIONS
Prevention of electric shock
The electrical connection must only be carried out by qualified personal. Before installing, make sure
you use the same power voltage marked in the MKL 144 IP WR (100-240V/50-60Hz). Each device must
be properly grounded and installed in accordance with the relevant standards. Don't use the device in
a lightning storm or wet environment.
To prevent burning of fire
1. Never install the device directly on the surface of ordinary combustible material.
2. The equipment must be installed away from inflammable and explosive materials.
3. Keep at last 0,5 m around the unit to ventilation purpose.
4. Do not place any object on the lens.
5. Do not replace with non-original spare parts. Contact your MARK dealer.
Unpacking: Note: Before unpacking, check it for possible damage that might have occurred during
transportation or not. If you find any damage, please do not use the unit, and contact the MARK dealer.
TROUBLESHOOTING
This short guide is meant to help and try to solve simple problems. If they continue and the device
cannot operate, please, don't try to repair it by yourself, return the device to your MARK dealer.
If a problem occurs, carry out the following steps in sequence until find the problem solved. If the light
effect does not operate properly, refer servicing to a technician.
No Light: Response: Suspect two potential problem areas: the power supply or the LEDs.
1- Power supply. Check that the unit is plugged into an appropriate power supply.
0 – 100%
0 – 100%
None
Color macro mode
(CH8)
Color jump mode
Color fade mode
Sound mode
Speed
0 - 255
0 - 255
0 - 4
5 - 80
81 - 150
151 - 220
221 - 255
0 - 255
6