To engage drive to the implement , engage the clutch lever and locate the control rod in its forward
position. I f engagement is not immediate , release the clutch lever slightly and feel-in
Throttle deceleration
Leave the power output control rod (PTO) free of attachments, the shift
lever in the neutral position, and then press down on the engine "OFF" button, until the engine stops
working
Note: the machine adopts normally open type clutch for power transmission, it conforms to the safety
standards EN 709-1992.
Note: when using the rotary cultivator, the machine can not be automatically moved to reverse position, as this design
this design ensures the safety of operators feet.
If the operator needs to switch the machine from forward gear state to reverse position, he must then
make sure the power output rod ( PTO ) is freed and then open the reverse control rod.
LU U U B B B R R R IC C C A A A TION N N A A A N N N D D D MA A A IN N N TEN N N A A A N N N C C C E
A proper maintenance and lubrication will help keep the machine in a perfect working condition.
Check that all screws and nuts arell tightened , particularly nuts D(fig.13) that fix the attachments to the
machine, the nuts that fix the wheels and the ones fixing the engine.
Lubricate the sliding bearings on the steering column stop rod.
CLUTCH
Originally position of Lever A is normal, but as the clutch wears out, the same lever could have
a wider opening, making it more difficult to use. This means that it is necessary to ajust the cable setting
lever, setting lever A to its original position by adjust ing nut B and C.
ENGINE
For the intervals between maintenance follow the instructions given in the engine operating
manual
You should check the oil level every 4 hours of work and replace it every 50 hours. Always use good
quality oil as indicated in the engine user manual.
For the oil bath air filter, if you work in dusty conditions, wash the filtering hank and add oil every 8 hours.
Use the same oil as for engine.
Page 15