BoomToneDJ PS12A-BT Modo De Empleo página 12

1 Bluetooth / TWS mode
To use your speaker via Bluetooth.
1. Switching on the speaker
2. Press the mode button to access Bluetooth
3. Connect your mobile device to the 'BOOMTONE DJ' Bluetooth settings
4. Play music on your mobile device and adjust the volume on the speaker using
button 16
TWS mode lets you use 2 PS12A-BT / PS15A-BT speakers in stereo Bluetooth. To do this,
you need 2 identical speakers.
Once the 1st speaker has been connected via Bluetooth using the procedure above;
1. Press the MODE button on the 1st speaker for 3 seconds
2. Switch on the 2nd speaker and switch to Bluetooth mode as well
3. Press the mode button on the 2nd speaker for 3 seconds. It will connect to the 1st
speaker in TWS mode.
4. Adjust volumes separately on each speaker
2. Line / AUX mode
1. Connect your loudspeaker to a 220 - 240VAC mains socket
2. Connect your source to the speaker. (Make sure all equipment is switched off
when connecting).
3. Switch on your source (CD player, mixer, etc.).
4. Check that all the levels on your speaker are at minimum, then switch the speaker
on. Button 17
5. Depending on the source connected, gradually increase the corresponding
potentiometer.
6. The loudspeaker can be placed on a 35mm loudspeaker stand.
3. Using a microphone :
The PS12A-BT is equipped with a microphone input (5 / 7). Connect a microphone to the
6.35mm jack or XLR input and adjust the microphone volume using the volume 1 knob (4).
A setting that is too high can weaken the speakers and cause feedback.
12