Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Use a soft dry cloth to wipe the surface of the unit clean.
For stubborn smudges, use a damp cloth that has been thoroughly
wrung out to remove excess moisture.
o Never spray liquid directly on this unit.
o Do not wipe with chemical cleaning cloths, thinner or other
chemical agents. Doing so could damage the surface.
o Avoid allowing rubber or plastic materials to touch the unit for
long periods of time because they could damage the cabinet.
V For safety, disconnect the power plug from the out-
let before cleaning.
Precautions for use
o This unit is very heavy, so take care to avoid injury during installation.
o Do not install this unit in a location that could become hot. This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment. Moreover, do not
place it on top of an amplifier or other equipment that generates
heat. Doing so could cause discoloration, deformation or
malfunction.
o In order to enable good heat dissipation, leave at least 20 cm (8")
between this unit and walls and other equipment when installing
it. If you put it in a rack, for example, leave at least 5 cm (2") open
above and 10 cm (4") open behind it.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o Place the unit in a stable location.
o Do not place anything on top of the unit.
o The voltage supplied to the unit should match the voltage as
printed on its back. If you are in any doubt regarding this matter,
consult an electrician.
o When removing the power plug from an outlet, always pull
directly on the plug. Never pull on the cord itself.
7
Publicidad
