Finder 83.02 Guia De Inicio Rapido página 2

83.02.0.240.0000
U : (24...240)V AC (50/60 Hz)/DC
N
U : 16.8 V AC /DC
min
U : 265 V AC /DC
www.findernet.com
max
P : <2 VA / <2 W
83.02 (AC/DC)
2 CO (DPDT)
12 A 250 V AC
AC1
AC15 (230 V AC)
M
~
(230 V AC)
1
DC1 (30 /110 / 220)V
(–20...+60)°C
IP20
1
A
B
C
D
E
86.2 mm
IB8302001- 03/13
2 3
3a
3000 VA
750 VA
0.5 kW
(12/0.3 /0.12)A
3b
100.3 mm
22.5 mm
3c
(AI)
(DI)
(GI)
(SW)
(BE)
(CE)
(DE)
(WD)
3d 3e
ENGLISH
83.02 MODULAR TIMER
1
FRONT VIEW
A = Time scale rotary selector
B = Time setting
C = LED
D = 2 timed contacts or 1 timed +1 instantaneous contact selector
E = Function rotary selector
2
TIME SCALES
3
WIRING DIAGRAM AND FUNCTIONS
(WARNING: the functions must be set before energising the timer)
3a Start via contact in supply line (A1).
AI = On-delay
DI = Interval
GI = Pulse delayed
SW = Symmetrical flasher (starting pulse on)
3b Start via contact into control terminal (B1).
BE = Off-delay with control signal
CE = On- and off- delay with control signal
DE = Interval with control signal on
WD = Watchdog (Retriggerable interval with control signal on)
3c Possible to control an external load, such as another relay coil
or timer, connected to the signal start terminal B1.
3d With DC supply, positive polarity has to be connected to B1
terminal (according to EN 60204-1).
3e A voltage other than the supply voltage can be applied to the
Start (B1) terminal, example:
A1- A2 = 230 V AC
B1- A2 = 24 V DC
Potentiometer (optional accessory).
*
OTHER DATA
Minimum control impulse: 50 ms.
Recovery time: 200 ms.
35 mm rail mount (EN 60715).
WORKING CONDITIONS
In conformity with the European Directive on EMC (89/336/EEC),
this timer has a level of immunity, against radiated and conducted
disturbances, considerably higher than requirements of EN 61812-1
standard. However, devices like transformers, motors, contactors,
switches and power cables may cause disturbances and even damage
the timer electronic circuit. For that reason, the wiring cables must
be as short as possible, and, when necessary, the timer shall be
protected by an appropriate RC network, varistor or surge protector.