Publicidad
Idiomas disponibles
Idiomas disponibles
9. Install eight M6 x 10 mm bolts (E) to tighten support
bars in the return frame (11). (See Figure 9)
Figure 9
E
11
10. Determine whether to install programmable
handset (9) in pilot holes on the main desktop (1)
or return top (10). In desired location, install
programmable handset using two ST5 x 16 mm
screws (G) and Phillips screwdriver. (See Figure 10)
Figure 10
PAGE 4 OF 24
ASSEMBLY CONTINUED
G
9
1
11. Connect the power cord (K), programmable
handset (9) and lifting column cables to the control
box (7). (See Figures 11-12)
NOTE: Two of the pre-installed lifting column
cables will not reach control box (7). Use the
extension wires (I) to connect lifting column
cables to control box.
Figure 11
9
Figure 12
Handset Cable
Lifting Column Cables
7
J
I
I
J
Power Cord (K)
7
K
1123 IH-11113
Publicidad
