VEVOR SGPC2000W-121 Manual De Operación página 10

sure all cables are securely fastened. Unsuitable The connection may
cause the cable to overheat and damage to the terminal block, and it will
too Shorten the power supply time of the battery.
Turn on the power switch, the working LED of the inverter will turn red
when the battery is fully charged, and when the inverter is in grid input
mode, the working LED of the inverter will turn green.
If there is any fault, the LCD display will show a fault icon, and then you
need to check whether the battery voltage is too high or too low, and check
if the inverter output is overloaded or short-circuited.
At the same time, the LCD will also display the fault code, please find out
and check the fault The reason is on
The DC power supply of a 12V inverter can be one 12V battery or
several opposing 12V batteries to increase the power supply time.
Note: The battery voltage connected to the inverter must be the same as
the inverter DC input voltage, such as the 12V inverter should be
connected to the 12V battery, and make sure that all the equipment is
turned off before powering on.
Dismantle steps.
1. First, turn off the inverter power switch.
2. Disconnect the power plug.
3. Dismantle the red DC cable.
4. Dismantle the black DC cable.
5. The done of dismantle.
With grid charger and UPS function.
Characteristics of Conventional inverter,Grid power first choice to protect
it powered all the time, grid power and battery switched automatically, UPS
continuous protection.(See Figure4)
page 12-13.
- 8 -