Celexon Professional eAdjust-58123 Manual De Instrucciones página 16

STEP 3: INSTALLATION FEET
Place the feet (1) on the Columns. Make
sure that the holes in the columns line
up with the holes in the feet. Fasten
the columns with the screws (C) and
tighten with the hexagon socket (F).
STEP 4: TABLETOP INSTALLATION
Release
The table frame can be adjusted to
the width of the tabletop. To do this,
loosen the screws (E) in the support
strut (4) with the Allen key (F). Make
sure that the screws are well loose-
ned, but not completely unscrewed.
Make sure that the support strut is
sufficiently wide (at least 2/3 of the
width of the tabletop).
ATTENTION: If the support strut is
extended over 172 cm, please follow
the installation step 6 Method 2.
Extend
Tighten
4