Publicidad
Idiomas disponibles
Idiomas disponibles
8.12
Area measurement
▪
Press button 2 three times to enter area measurement mode. The area icon (A) will be
displayed.
▪
Press button 1 again to measure the length and press button 1 again to measure the width
of the rectangle. The measurement area will be displayed at the most downtrend of the
display screen.
8.13
Volume measurement
▪
Press button 2 four times to enter volume measurement mode. The volume icon (B) will be
displayed.
▪
Press button 1 again to measure the length, press button 1 again to measure the width
and press button 1 again to measure the height of the cube. The measurement volume will
be displayed at the most downtrend of the display screen.
8.14
Addition measurement
▪
Press button 2 five times to enter addition operation measurement mode. The addition
icon (+) will be displayed.
▪
Press button 1 again to make a single measurement, continue to make a single
measurement. The cumulative value of the two measurements will be displayed at the
most downtrend of the display screen. Keep doing as many single measurements as
needed.
▪
The measurements of n times have always been cumulative and displayed on the most
downtrend of the display screen.
8.15
Subtraction measurement
▪
Press button 2 six times to enter subtraction operation measurement mode. The
subtraction icon (-) will be displayed.
▪
Press button 1 again to make a single measurement, continue to make a single
measurement. The cumulative value of the two measurements will be displayed at the
most downtrend of the display screen. Keep doing as many single measurements as
needed.
▪
The measurements of n times have always been cumulative and displayed on the most
downtrend of the display screen.
8.16
Message code
Message code
Err01
Err02
Err03
Err06
Copyright © 2023 VARO
KRT706500
Possible Cause
The reflected laser signal is
too strong.
The distance to be measured
is beyond the measuring
range. The specified
measuring range of this
instrument is 0.05~20m
The target which the laser
beam aims at is weak at
reflecting the laser beam.
Low battery
P a g e
Remedy
Change the target or affix a
piece of white paper to the
target.
Measure within the effective
measuring range.
Change the target or affix a
piece of white paper to the
target.
Replace with a new battery
| 8
EN
www.varo.com
Publicidad
