Auxiliary Functions - Zodiac K-3000 Manual De Usuario

OPERATION
Release the PTT switch to receive signal.
Note: When the battery pack voltage becomes too low, transmission will stop and the LED will
blink red, See "Low Battery Warning".

AUXILIARY FUNCTIONS

Time-out Timer
The purpose of the Time-out Timer is to prevent any person from using a channel for an
extended period of time.
If you continuously transmit for 60 seconds, the transceiver will stop transmitting and a tone will
sound.
To stop the tone, release the PTT switch. You can press the PTT switch again to resume
transmitting.
Battery Save
The Battery Save function decreases the amount of power used when a signal is not being
received and no operations are being performed (no keys are being pressed, and no switches
are being turned).
While the channel is not busy and no operation is performed for 30 seconds, Battery Save turns
ON.
When a signal is received or an operation is performed, Battery Save turns OFF.
Low Battery Warning
Low Battery Warning alerts you when the battery needs to be recharged.
While transmitting, if the battery power goes below a pre-deter- mined value, the LED will blink
red. When a tone sounds, the transceiver stops transmitting.
Replace or recharge the battery pack.
Switch ON the transceiver by turning the Power
switch/Volume control clockwise.
♦ A beep sound
Adjust the volume by rotating the
Volume control.
Toggle the Channel switch to se- lect your desired channel.
♦
When you receive an appropriate signal, you will hear
audio from the speaker.
To make a call, press and hold the PTT switch, then speak
into the microphone using your normal speaker voice.
♦
Hold the microphone approximately 1.5 inches (3 to 4cm)
from your lips