Publicidad
Idiomas disponibles
Idiomas disponibles
6. Timer (0 ~ 15 minutes)
7. Timer indicator light
8. Food handling tong
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Heating control knob
(Fig.2 on page 3)
• This appliance makes use of quartz heating rod for prompt
heating.
• Different settings of the heating control knob are described
below:
9. Switch OFF the appliance
10. Provide heating power for the upper heating rod.
11. Provide heating power for the middle & lower heating rods.
12. Provide heating power for the upper, middle & lower heating
rods.
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
• Before start, make sure the heating control knob is at the "0"
position & timer is at the "0" position.
• Plug into a suitable electrical outlet.
• Then, place the toast or food on the protective shelf using the
supplied food handling tong.
• Next, set the heating control knob to the desired setting and
the timer to the desired time (Range: 0 ~ 15 minutes). Timer
indicator light will go on.
• A sound will be heard after the set time is elapsed. Timer
indicator light will go off.
• Use the supplied food handling tong to remove the toast or
food in order to avoid burns. Wear heat -resistant gloves if
necessary (not supplied).
Note:
• Actual cooking time depends on the number of factors such
as type and thickness of the food, the desired degree of cook-
ing.
• It can stop heating any time when rotating the timer to the
0 minutes.
• Try to set few minutes for the timer to avoid overcooked.
• CAUTION! Always use the supplied tongs to remove the food
in order to avoid burn.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
• Clean the crumb tray regularly: crumbs can smoke or burn.
• DANGER! RISK OF ELECTRIC SHOCK! DO NOT TOUCH ANY
PART OF THE TOASTER WITH SHARP OR METAL UTENSILS,
ESPECIALLY INSIDE THE BREAD TOASTING SLOTS.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
GB
7
Publicidad
