Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY & INSTALLATION
Before connecting the appliance to a power source, let it stand
upright for approximately 24 hours. This will reduce the possibility of
a malfunction in the cooling system from handling during
transportation.
This beverage fridge is a freestanding unit and should not be built into
surrounding cabinetry. Allow for proper air clearance around the fridge. The
recommended clearances are as follows:
Sides: 4.5"
Top: 4"
Back: 4"
Before operating your beverage fridge for the first time, follow these steps:
1. Allow the unit to sit upright for 24 hours prior to first use. Upon the first
use, allow the unit to sit at the desired temperature for at least 30 minutes
before changing settings or filling it with drinks.
2. Clean the interior surface of the unit with warm water and a soft cloth.
3. Handle the unit with care. Do not apply force to any parts, such as the
condenser or the door. The metal rails on the bottom of the unit may be
sharp, so please use caution when moving the unit. Do not tilt the unit
beyond 45 degrees or drag it across the floor.
4. Place the fridge on a level surface that will be strong enough to support
the unit when it is fully loaded. To level your fridge, adjust the front feet
located at the bottom of the unit. If the unit is not level, the doors and
magnetic seal may not work properly. (Please note that placing your fridge
on carpet may result in expelled heat fading the carpet.)
5. Install the fridge away from direct sunlight and heat sources such as
stoves, heaters, or radiators. Direct sunlight may affect the unit's acrylic
coating, and nearby heat sources can increase electrical consumption.
Extreme cold or hot ambient temperatures may also prevent optimal
performance.
www.newair.com
EN
14
Publicidad
