Publicidad
Idiomas disponibles
Idiomas disponibles
To remove and replace the freezer floor:
1. Lift both back "fences" up and out.
2. Remove the freezer floor by pulling it out about 1 in.
(25.40 mm) with one hand around the air tower section
(center back) and one hand at center front.
3. Lift up floor at rear until hooks release from cabinet and pull
the floor out the rest of the way.
4. Replace the freezer floor by sliding the floor straight in until
the hooks drop into place at rear of cabinet.
5. Replace "fences" by aligning pins with socket in the floor, and
pushing down until they snap into place.
NOTE: Can racks may be purchased as an Accessory for some
models.
To remove and replace the racks/bins:
1. Remove the rack/bin by lifting it and pulling it straight out.
2. Replace the rack/bin by sliding it in above the desired
support and pushing it down until it stops.
Adjk st2
Compa tme" t
&
ay
DOOR
Your model may have some or all of these features. Features that
can be purchased separately as product accessories
are labeled
with the word "Accessory."
Not all accessories will fit all models.
If you are interested in purchasing one of the accessories,
please
call the toll-free number on the cover or in the "Assistance
or
Service" section.
The utility compartment
and tray slide from one side to the other
for more flexible storage. The tray fits on either side of the utility
compartment
or partially underneath it. Try moving it to different
positions to find the option that works best for you.
To install and adjust the utility compartment
and tray:
1. Insert the front of the utility tray into the slot on the back of
the shelf rail. Lower the back of the tray into position.
2. Place the front of the utility compartment
on top of the shelf
rail. Lower the back of the compartment
onto the ribs on the
refrigerator door.
The door rails may be removed for easier cleaning.
Snap-on
Door Rails
To remove and replace the rails:
1. Remove the rails by pushing in slightly on the front of the
bracket while pulling out on the inside tab. Repeat these
steps for the other end of the rail.
2. Replace the rails by aligning the ends of the brackets with the
buttons on the sides of the door liner. Firmly snap bracket
and rail assembly onto the tabs above the shelf as shown.
3. Adjust the utility compartment
by lifting the front slightly and
sliding it to the desired position. Lower the front to lock it into
place.
Drop-in
Door Rails
The shelf bottom flips up so you can store taller items in the door
To remove and replace the rails:
shelf below. When in the down position, the shelf is strong
enough to hold up to 10 Ibs. (4.5 kg).
1. Remove the rails by pulling straight up on each end of the rail
2. Replace the rails by sliding the shelf rail into the slots on the
door and pushing the rail straight down until it stops.
13
Publicidad
