Beta 019660091 Manual De Instrucciones página 11

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
KEY TO SYMBOLS
1. Chuck
2. Button
3. Locking button
4. Reverse switch
5. Speed regulator
6. Mode selector
7. Side handle
USE
Power supply connection
For correct use, the plug of the electric tool must match the socket. Do not use any adapters with earthed electric tools. Check
that the power supply meets the specifications in the Technical Data table.
Operation
Do not press the start button before connecting the electric tool.
Discontinuous mode:
• Press button (2) to start the electric tool
• Release button (2) to stop the electric tool
Continuous mode:
• Press button (2) to start the electric tool and lock it by means
of locking button (3).
• Press and release button (2) to unlock and stop the electric tool.
Speed regulation
• The tool is equipped with speed regulator (5). Regulate speed
as follows:
• Turn speed regulator (5) towards the ''+'' symbol to increase
speed.
• Turn speed regulator (5) towards the ''-'' symbol to decrease
speed.
Setting direction of rotation
Check that button (2) has been released from the locking
position and that the motor is not running. Select the direction
of rotation of the electric tool by means of reverse switch (4), as
shown below.
- Anticlockwise direction: press the reverse switch on the left
side of the tool handle (seen from the operator's side)
- Clockwise direction: press the reverse switch on the right side
of the tool handle (seen from the operator's side)
EN I
11