Black Diamond RECON X Manual De Instrucciones página 22

6.5 DISPOSAL
NOTICE Please note that the device is an electronic device. It cannot therefore be
disposed by public waste management companies. Dispose of the device in
accordance with the law in your country.
7. CONFORMITY
EUROPE
Black Diamond Equipment declares that the radio equipment type BLACK DIAMOND RECON X is in compliance
with Directives: EMC 2014/30/EU, RED 2014/53/EU, RoHS 2011/65/EU, LVD 2014/35/EU.
UK
Black Diamond Equipment declares that the radio equipment type BLACK DIAMOND RECON X is in compliance
with Electromagnetic Compatibility Regulations 2016, Radio Equipment Regulations 2017, The Restriction of the
Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012, Electrical
Equipment (Safety) Regulations 2016
The full text of the EU and UK declarations of conformity is available at the following internet address:
www.blackdiamondequipment.com/DOC
USA/CANADA
Manufacturer: Black Diamond Equipment | Type/Model: BD Recon X
USA: FCC Notice, Cautions and Statement
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residual installation. This equipment generates, uses and can radiate frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
BLACK DIAMOND RECON X MANUAL 21