Textron Company GREENLEE CM-900 Manual De Instrucciones página 9

Operation
1. Set the selector according to the Settings Table. For DC current, start with the 600 A range.
2. Refer to "Typical Measurements" for specific measurement instructions.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the
battery (or batteries).
• If the unit still does not function as expected, send the unit to Greenlee for repair. Refer to
the instructions under the Warranty.
4. Take the reading from the circuit or component to be tested.
5. If it is a DC current reading, remove the clamp from the circuit and press the ZERO button.
Clamp the jaw around the circuit again to measure the actual DC current.
If the resolution is not satisfactory on the 600 A range, remove the meter from the
conductor and switch to the 400 A range. Repeat steps 4 and 5.
Settings Table
To measure
this value ...
Continuity*
Resistance
DC Voltage
AC Voltage
DC Current (600 A max.)
DC Current (400 A max.)
AC Current (600 A max.)
Frequency
* Tone sounds if the measured resistance is less than approximately 30 Ω.
Electric shock hazard:
Contact with live circuits can result in severe injury or death.
set the selector
to this symbol ...
Hz
connect the
red lead to ...
V-Ω
V-Ω
V-Ω
V-Ω
Remove lead
Remove lead
Remove lead
Remove lead
CM-900 • CM-950
and connect the
black lead to ...
COM
COM
COM
COM
Remove lead
Remove lead
Remove lead
Remove lead
9