Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Mower will not mulch grass
Uneven cut
Mower will not self propel
High pullback effort
TROUBLESHOOTING
Cause
1. Wet grass.
2. Excessively high grass.
3. Dull blade.
1. Dull blade.
1. Belt not installed properly.
2. Debris clogging drive operation.
3. Damaged or worn belt.
4. Drive control out of adjustment.
1. Pulling mower backwards before transmission
disengages.
1. Do not mow when grass is wet; wait until
later to cut.
2. Mow once at a high cutting height, then mow again at desired
height or make a narrower cutting path.
3. Sharpen or replace blade.
1. Sharpen or replace blade.
1. Check belt for proper pulley installation and
movement.
2. Stop engine, disconnect spark plug boot,
and clean out debris.
3. Inspect and replace belt.
4. Adjust drive control. See Drive Adjustment in Service &
Maintenance section.
1. Allow the unit to roll forward slightly without the drive lever(s)
engaged before pulling backwards.
24
Remedy
Publicidad
