Publicidad
Idiomas disponibles
Idiomas disponibles
5
This Wet/Dry Vac converts to a detachable blower that can be used for leaf blowing in yards, decks and patios. To use
the detachable blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA, CSAZ94.3)
BEFORE USING BLOWER.
CAUTION:
TO REDUCE THE RISK OF HEARING DAMAGE, WEAR EAR PROTECTION WHEN USING THE VAC/
BLOWER FOR EXTENDED HOURS OR WHEN USING IT IN NOISY AREAS.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Squeeze the locking lever and lift the detachable blower from the vacuum lid. (fig. 2 & 3)
3. Insert the adaptor into the blowing port and fit it the desired extension wands and or nozzles. (fig. 4 & 5)
4. Ensure the power switch is turned off and plug into the power supply. (fig. 6)
5. Firmly hold the blower before turning it on. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 7)
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING THE POWER
HEAD FROM THE CONTAINER.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Disconnect the hose from the unit. (fig. 2)
3. Undo the latches and remove the power head from the container. (fig. 3)
4. Clear all dirt or debris from the container and hose. (fig. 4)
5. Clean the foam filter by washing it with water and mild soap. (fig. 5)
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
BLOWING OPERATION
2
MAINTENANCE
2
3
7
6
4
3
9
4
5
Publicidad
