Host HA3 Manual De Instrucciones página 3

USE AND UPKEEP INSTRUCTIONS
Control costs by using the HOST Applicator. The three applicator settings, light, medium or
heavy, take the guesswork out of applying HOST Cleaner. Load the Applicator, open to the
desired setting and apply. The uniform piles of HOST Cleaner will not dry out quickly. Spread
up to 500 square feet at a time before brushing.
1
Be sure the hole covers
are closed before filling
the Applicator. Attach the
handle by screwing it into
the crossbar. Unscrew the 2
knobs on the fill port cover
and remove the cover. Set
aside. Fill the Applicator
with up to 12 lbs.(5.4 kg.) of
HOST Cleaner. Replace the
fill port cover and tighten
the knobs.
2
To uncover holes for HOST
Cleaner application, loosen
both screw knobs on the
hole cover(s) and slide the
cover(s) open until the holes
are visible. Slide one, two
or three hole covers open to
dispense HOST Cleaner.
Light soil: slide 1 hole cover
open.
Medium soil: slide 2 hole
covers open.
Heavy soil: slide 3 hole
covers open.
Most Cost Efficient
The most cost efficient way to use your
HOST Applicator is to select the setting
for the lightest, average degree of soil
for your cleaning job. For example, if
the area to be cleaned is lightly soiled
but with a few bad spots or visible
traffic lanes, set Applicator on "Light"
and use more HOST Cleaner on more
heavily soiled areas.
THE CLEANING SYSTEM that makes A DIFFERENCE
Open hole covers
for HOST Cleaner
application
hostdry.com | 800-558-9439
3
Walk along soiled carpet to
dispense the right amount
of HOST Cleaner. Walk at
a slow pace. Less HOST
Cleaner is dispensed when
you walk fast. This may affect
cleaning results. Be careful
not to allow the piles of HOST
Cleaner to stand too long
before brushing. Clean "dots"
may result which will be
difficult to blend. Commercial
carpet which is being
maintained on a regular,
planned basis will require the
light or medium setting. On
residential carpets, use the
heavy setting, because of the
thicker pile.
For Heavy Soiled Areas
Traffic lanes - walk the Applicator over
the traffic lanes first; then apply as usual
to the entire area including the traffic
lanes for the second time. This will apply
extra HOST Cleaner where it is needed.
Severe spots - push the Applicator back
and forth over the spot.
Funnel areas - treat heavier soil in
doorways and other funnel areas by
giving an extra push-pull motion where
more soil is visible.
4
FOR HEAVILY SOILED
CARPET. The heavy setting
should be used only on
extremely soiled carpets.
Note: If carpet seems soiled
after cleaning, you may
need to reapply and brush
again.
3