Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety
Symptom
Light does not switch
off after set time has
elapsed.
When setting the
controls in daylight
the detection distance
becomes shorter.
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 6
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 6
Possible Cause
Time is set for too long.
The unit is operated in the mode of
the motion sensor being deactivated.
Unit damaged due to maximum load
exceed or incompatible load type
or failure of the load (such as short
circuit).
Continuous movement in the
detection zone.
Light being operated in the detection
zone causing sensor to respond as a
result of change in temperature.
Interference by sunlight.
Solution
Reduce time (TIME knob).
To activate the motion sensor.
Identify and fix the cause of failure.
Replace the unit with a new one.
Change detection zone / Relocate
the unit.
Change detection zone / Relocate
the unit.
Re-set controls at night.
6
21/10/2021 6:17 PM
21/10/2021 6:17 PM
Publicidad
