Publicidad
Idiomas disponibles
Idiomas disponibles
Straightening your hair
If you use the straightener incorrectly or if you use it at the wrong temperature,you could overdry your hair or
even burn it.Always follow the steps below to select the right temperature for your hair type:
!
Always select a low heat setting when you strat using the straightener for the first time.
!
For coarse,curly or hand-to-straighten hair,selected a medium(120
!
For fine,medium-textured or softy
waved hair,select a medium(120
!
Take extra care with pale,blonde,bleached or colour-treated hair,since it will be susceptible to damage at
high temperature.
The specific steps to use the appliance:
1. Insert the plug into the wall socket.
2. Press the on/off button.
The pilot light turns red when switch it on and turns to green when the selected temperature reaches..
3. Let the appliance heat up.The defaut heat setting is 140
Never leave the appliance unattended when it is plugged in.
Never put the appliance on a surface that is not heat-resistant when it is heating up and when it is hot.
4. When the temperature-showing setting shows 140
Press the + button to increase the temperaure or press the "button to decrease the temperature.
5
can be changed at one time when you press the +/" button.The display tells you which temperature you
!
have selected.
5. Comb or brush your hair so that it is disentangled and smooth.
Use a comb to divide the hair into sections.Do not put too much hair in one section.
6. Take a section that is not wider than 5 cm.Place it between the straightening plates and press the handles
of the appliance firmly together.
7. Slide the straightener down the length of the hair for 5 seconds,from root to hair end,without stopping to
prevent overheating.
8. Repeat this process after 20 seconds until you have achived the desired look.
9. Allow your hair to cool down.Do not comb or brush it before it has cooled down,as this would ruin the
hairstyle you have just created.
Cleaning
1. Switch the appliance off by pressing the on/off button.
2. Unplug the appliance.
3. Let the appliance cool down completely on a heat-resistant surface.
4. Clean the appliance with a damp cloth.
Storage
1. Make sure the appliance is unplugged.
2. Let the appliance cool down on a heat-resistant surface before storing it.
Rated Parameters
Voltage:120V
Frequency:60Hz
Power:60W
) to high heat setting (160
)
!
!
) to low heat setting (80
).
!
!
.
!
,you can adjust the temperature to your preference:
!
Page 2
Circuit Diagram
Page 3
Publicidad
