Xblitz S3 DUO Manual Del Usuario página 7

01. CONTENTS OF THE KIT
1. Car camera Xblitz S3 Duo
2. Rear-view camera
3. Micro SD memory card reader
4. Holder with suction cup
5. Charger
6. AV cable (for rear view camera)
7. Instructions
02. PRODUCT DESCRIPTION
SEE FIGURE A
1. Menu/ Mode button
2. UP button
3. Down button
4. POWER/ RECORD button
5. Loudspeaker
6. Lens
7. Micro SD memory card slot
8. AV port (for rear camera connection)
9. Mini USB port
10. RESET button
11. Handle with 360° adjustment
03. DESCRIPTION OF THE KEYS
1. POWER
To switch the camera on or off, hold down the button for approximately 3
seconds. A short press of the button turns video recording on or off or wakes up
the screen from the screensaver function.
2. MENU/ MODE
Longer press to open the context menu (if, at the same time, the camera is
not recording an image). Longer presses switch to video / photo and file view
modes. In MENU and browse mode
functions as an undo key. Briefly pressing the key during video recording
protects the currently recorded file from being overwritten.
3. DOWN
In file browsing mode, pressing the button switches between files stored on the
memory card or in the device menu. In video mode, pressing the button turns
sound recording on or off.
4. UP
In menu and file browsing modes, it is responsible for navigating through the
individual items. In video and photo modes, pressing the button switches the
12
view between the front and rear cameras.
5. RESET
Pressing the button resets the device and returns it to factory settings.
04. CAMERA INSTALLATION
1. Choose where to mount the camera. It is best to position the camera so that
the display preview shows as much of the area in front of the car as possible.
Make sure that the camera does not obstruct the driver's view while driving.
2. Mount the bracket on the windscreen, then install the camera in it.
3. Route the USB cable so that it does not impede driving.
4. Route the reversing camera cable and plug it into the camera.
5. Connect the mini USB plug to the camera and plug the charger into the
12/24V cigarette lighter socket.
Where to mount the additional camera included in the kit depends on your
preference . The camera complies with waterproof standards IP67 (completely
dustproof and protected against immersion in water - max. 30 minutes at a depth
of up to 1 metre).
Back-up camera connection:
Connect the back-up camera cable to the AV port, which is located on the main
video recorder housing. Make sure the main unit can see the secondary camera (if
not, check the camera settings in the main menu or
check that the camera cables have been installed correctly).
Reversing camera installation:
The wires coming out of the rear camera should be connected to the wires feeding
the reverse lamp. Connecting the wires in this way will allow the rear camera view
to be activated when reversing. The outgoing installation should be well insulated
and should not be mechanically stressed.
ATTENTION ! Mount the rear camera with the mounting foot upwards. Mounting
with screws or double-sided tape.
ATTENTION ! The rear view camera captures a mirror image.
05. DEVICE FUNCTIONS
1. Dual camera - allows you to disable or enable recording by the rear camera.
2. Loop recording - setting the recording time (length) of video files, when the
memory card fills up the oldest recording will be overwritten.
3. HDR (high dynamic range) - allows a wide dynamic range to be enabled
(ability to capture detail in the brightest and darkest parts).
4. Exposure - allows you to adjust the light sensitivity of the lens.
5. Motion detection - this mode starts recording when the camera detects
movement (e.g. a person in front of the vehicle). The function only works
13