NORAUTO 96638 Manual página 48

Arbor Plates. Such items create an uneven surface which can cause the Arbor Plates to
break under pressure.
WarnInG! When pressing two items together, the items must be lined up vertically. If
not. one item may forcefully eject itself sideways from the unit.
3. Using the Jack Handle (23), jack down the Jack Plate until the ram of the Jack Plate
contacts the workpiece. When pressing two items together, make sure that they are in
vertical alignment. Continue to operate the Jack Handle to press the work piece
4. After the task is completed, be careful when releasing Jack pressure. For safety, remove
the Jack Handle, then use the Handle to slowly turn the Valve Release Screw on the
Jack, allowing the Jack Plate to rise.
WarnInG! During the release process the Jack may rise quickly. Stay clear.
User-maIntenanCe InstrUCtIons
Procedures not specifically explained in this manual must be performed only by
a qualified technician.
WarnInG
to PreVent serIoUs InJUrY From tool FaIlUre:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the
problem corrected before further use.
1. Before each use, inspect the general condition of the Shop Press and Bottle Jack.
Check for broken, cracked, or bent parts, loose or missing parts, and any condition that
may affect the proper operation of the product. If a problem occurs, have the problem
corrected before further use.
Do not use damaged equipment.
2. Before each use, thoroughly test the Bottle Jack (6) for proper operation prior to its
actual use. If the Bottle Jack appears not to be working properly, follow Bleeding
the Bottle Jack instructions.
3. Change the hydraulic oil at least once every three years. to change the hydraulic
oil:
• With the Jack fully lowered, unhook the Springs (5) from the Eye Bolts (8), remove two
bolts (7), and remove the Jack from the Jack Plate (17).
• Remove the Oil Filler Plug.
• Tip the Bottle Jack to allow the old hydraulic oil to drain out of the unit completely, and
dispose of the old hydraulic oil in accordance with local regulations.
• Completely fill the unit with a high quality hydraulic oil (not included) until the oil just
begins to run out of the Oil Fill Hole.
• Reinstall the Oil Filler Plug.
• Clean with a clean cloth using a detergent or mild solvent.
• Replace the Bottle Jack onto the Jack Plate (See step 9 under Assembly Instructions).
47