Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Ensure the gasket (B) is on the bottom of the
new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
S ecure the faucet (A) to the sink using the easy
install nuts (C) provided, push up the easy install
nuts (C) to sink and hand-turn to tighten, as
shown in the Fig 1.
NOTE: If the sink is uneven, use silicone under the
gasket (B).
C
Sink
Push
up
C
A
Screw
Sink
Fig 1
2
Preparing the pop-up assembly
□
Remove the pop up stopper (D) and drain
ange (E) from the drain body.
□
Screw the lock nut (G) all the way down, and
push the rubber washer (F) down.
B
4
F
G
D
E
Publicidad
