Craftsman 919.167243 Manual De Instrucciones página 16

Customer Responsibilities
3heck Safety Valve
Drain Tank
Before
each
Jse
@
Daily
or after
each
use
O
cycles automatically when power
is on. When servicing, you may
be exposed to voltage sources,
compressed air, or moving parts.
Before servicing unit unpmug or
disconnect emectricamsuppmy to
the air compressor, bleed tank
of pressure, and allow the air
compressor to cool
NOTE: See "Operation" section for
the location of controls.
To Check Safety Valve
To Drain Tank
1. Set the On/Auto/Off lever to
"OFF" and unplug unit.
2. Pu!I the regulator knob out and
turn counterclockwise to set the
outlet pressure to zero.
3. Remove the air toot or accessory.
4. PulI ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 psi. Release safety valve ring.
5. Drain water from air tank by
opening drain valve (counter-
clockwise) on bottom of tank.
does not work properly, over_
pressurization may occur, causing
air tank rupture or an expBosion.
1. Before starting compressor, putl
the ring on the safety vane to
make sure that the safety valve
operates freely. If the valve
is stuck or does not operate
smoothly, it must be repiaced
with the same type of valve.
condense in the air tank. mfnot
drained, water will corrode and
weaken the air tank causing a risk
of air tank rupture.
6. After the water has been drained,
close the drain vane (clockwise).
The air compressor can now be
stored.
NOTE: If drain valve is plugged,
release alI air pressure. The valve
can then be removed, cleaned, the
reinstalled.
A08599 16-ENG