Publicidad
Idiomas disponibles
Idiomas disponibles
DISTORTIONS:
▪ The speakers may be overloaded or defective, lower the level and then readjust the level.
This setting can be adjusted as follows:
a) On the radio/player, play any musical signal and set the volume to 80% of the
maximum (if the maximum volume of the radio /player is 45 (100%), set to 36 (80%).
b) On the amplifier, begin with the LEVEL control at minimum, increase gradually
until the LED CLIP starts to flash. Slowly decrease the LEVEL until the led goes out
completely.
WEAK OF BASS:
▪ Cables of the speakers may be reversed
NOISE AND FAILURE IN SOUND:
▪ Make sure that the installation is not close to the vehicle's original wiring as it may
cause interference and noise in the audio signal.
▪ Create a separate power connection for the sound system. Use a fuse/ circuit breaker
as close to the battery as possible for protection.
▪ Make a good grounding for the amplifier. To do this, remove the paint from the vehicle
chassis at the desired point. Attach the wire using a ground terminal. To prevent oxidation,
isolate with paint.
▪ Do not loop the ground. Avoid using multiple grounds. If possible, use a star connection,
so all the grounds run from a single point.
Images contained in this manual are merely illustrative and may differ from the actual product.
and
(speakers out-of-phase).
8
Publicidad
