Initial Setup - DeWalt DCT416 Manual De Instrucciones

ASSEMBLY
Belt Hook (Fig. 3) (Optional Accessory)
WARNING: To reduce the risk of serious personal injury, DO
NOT suspend tool overhead or suspend objects from the belt hook.
ONLY hang tool's belt hook from a work belt.
WARNING: To reduce the risk of serious personal injury,
ensure the screw (N) holding the belt hook is secure.
IMPORTANT: When attaching or
removing the belt hook, use only
the screw (N) that is provided.
The belt hook (O) can be
attached to either side of the
tool using only the screw (N)
provided, to accommodate left-
or right-handed users. If the hook
is not desired at all, it can be removed from the tool.
To move belt hook, remove the screw (N) that holds the belt hook in
place then reassemble on the opposite side.
OPERATION
Installing and Removing the Battery Pack
(Fig. 4)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (A) into the tool handle, align the battery with
the rails inside the tool's handle and slide it firmly into the handle until
you hear the lock snap into place.
FIG. 3
O
N
9
FIG. 4
A
To remove the battery pack from the tool, press the release button (P)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Getting Started (Fig. 2)
1. Slide lens cover (G) down to expose the lens.
Power On/Off
1. To turn on the imaging thermometer, push the menu/power button
(L) and hold for 0.5 seconds.
2. To turn off the imaging thermometer, push the menu/power button
(L) and hold for 3 seconds.

INITIAL SETUP

Date and Time Setup
The first time the imaging thermometer is powered on, it will prompt to
set the time and date. After the initial setup, the time and date can be
changed through the menu navigation.
1. Press the forward (J) or back (H) arrow to highlight the field to
change.
P