Silverline 100048 Manual Del Usuario página 4

GB
Description of Symbols
The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Double insulated for additional protection
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice
Specification
Voltage: ................................................ 230V~
Frequency: ........................................... 50Hz
Staple size: .......................................... Type 53, 8-16mm
Nail size: .............................................. 10-16mm
Firing rate: ............................................ 20/min
Weighted vibration: ............................. 1.7m/s
Uncertainty ........................................... 1.5 m/s
Sound pressure: ................................... 87.0dB(A)
Sound power: ....................................... 100.0dB(A)
Uncertainty ........................................... 3 dB(A)
Protection Class: ..................................
The sound intensity level for the operator may exceed 85dB(A) and
sound protection measures are necessary.
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
4
Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this tool, do not attempt to use it.
General Safety
Clean the work area
• Accidents can occur where benches and work areas are cluttered or
dirty. Keep floors clear and avoid working where the floor is slippery. If
working outdoors, be aware of all potential slip and trip hazards before
using this tool
Children and pets
• Keep children and pets at a safe distance from the work area. Lock tools
away where children cannot gain access
Trained, competent persons
• This tool should be used by trained, competent persons only
Wear suitable clothing and footwear
• Do not wear loose fitting clothing, neckties, jewellery, or other
items which may become caught. Wear non-slip footwear or, where
appropriate, footwear with protective toe caps. Long hair should be
covered or tied back
Protective equipment
• Refer to the rating plate on your tool for information relating to the
necessary protective equipment when using this product. Example; dust
mask/respirator, goggles, ear defenders, gloves etc
Check for damaged or missing parts
• Before each use, check if any part of the tool is damaged or missing.
Carefully check that it will operate properly and perform its intended
function. Check alignment of moving parts for binding. Any guard or other
part that is damaged should be immediately repaired or replaced by an
authorised service centre. DO NOT USE IF DEFECTIVE
Use the correct tool
• Do not force or attempt to use a tool for a purpose for which it was not
designed. This tool is not intended for industrial use
2
Accessories
2
• The use of any attachment or accessory, other than those mentioned in
this manual, could be dangerous and result in damage or injury, and may
invalidate your warranty
Secure work
• Where possible, always secure work. If appropriate, use a clamp or vice
so that both hands are free to operate the tool
Keep your balance
• Do not over-reach. Keep secure footing at all times and do not use tools
when standing on an unstable surface