Publicidad
Idiomas disponibles
Idiomas disponibles
promshop.biz
3. Getting started:
•
Unscrew the battery compartment screw
•
Insert the AA batteries respecting the polarity
•
Close the lid and tighten the screw.
The device is ready to start listening to a machine
with the chosen contact probe: the short one for
easy to access machinery, and the long one for
spaces with limited access. For this reason, do not
direct it at any moving part of a machinery.
Please follow the steps below when setting up
the device:
•
Screw the chosen probe tip to the device and
tighten it gently.
•
Plug the cable to the headset outlet, use the
90 degrees angle jack plug side.
•
Plug the other end of the cable to the device
and secure the jack plug with the thumb screw.
•
Push the ON/OFF button for 2 seconds to turn
the stethoscope ON.
•
Direct the device at a running machine.
•
Push gently to contact the tip of the probe to
the non-movable machine area of your choice.
•
Use the desired volume level by pressing the
direct access buttons 1 or 2 for changing the
volume Down or Up.
АО БЕРГ АБ (495) 727-22-72 mail@promshop.biz
4. General usage
The Stethoscope offers a wide range of volume level
to operate it and many different functions. When
simply listening to a machine, by pressing the left
or right button (button 1 and 2), the volume goes
Down or Up.
By pressing one more time on Direct Access button
1 at minimum Volume, it will Mute the Stethoscope.
Use the two probes depending on the ease of access
of the area where you want to listen.
4/5
.
Fig. 5 – Volume popup
When the user changes the sound volume a popup
appears and the stethoscope gives an audio indication
of the current sound volume (beep).
The popup disappears after 2 seconds.
The output jack plug on the side is there in order to
plug a recording device (not sold by SKF).
7
EN
Publicidad
