Kite Optics APC 50 Manual Del Usuario página 7

USE OF THE DEVICE WITHOUT POWER
apart of power on and off, the power switch also acts as a physical lock for the internal gimball. When the device enters SLEEP mode while the power switch is
still in the ON position, the internal gimball system is no longer actively powered but will be free in movement. This free movement can be felt when shaking the
binocular, or seen when looking through the binoculars as a very unstable and shaky image. In the same way, placing the power switch to ON position while
no batteries are placed or with a dead battery, will cause the gimball system to be unlocked and move freely. This is normal.
You can perfectly use the device as a conventional binocular when no battery is placed or when battery is dead, only keep in mind to put the power switch
in OFF position so the gimball is locked.
FIRST USE
A. Attach the neck-strap to the neck-strap passage way on both sides.
Attach a hand-strap Attach a neck-strap
B. For use while wearing spectacles, do not twist up the eyecups. For use without wearing spectacles, twist up the eyecups by turning them anti-clockwise.
C. Look through the binoculars and adjust the interpupillary distance by folding the eyepieces in or out, untill you see one nice and round image.
D. Adjust the diopter setting. To achieve optimal image quality, the possibly varying visual acuity between the left and right eye must be corrected.
// Use without eyeglasses and equal acuity of both eyes, or with eyeglasses. Place the diopter ring in middle neutral position.
(allignment of indications in diopter wheel and rubber)
// Use without eyeglasses and varying acuity.
Look through the left eyepiece with your left eye and turn the focus wheel to focus sharply on a selected object. Now look at that same object through
the right ocular with your right eye and again create a sharp image of this object by turning the diopter ring only.
Now the dioptric correction has been set for our particular visual acuity.