Singing rock BLAST Manual Del Usuario página 3

ENG
INSTRUCTIONS FOR USE
SPECIFIC INSTRUCTIONS FOR USE
This product is a Personal Protective Equipment (PPE) category II for head
protection.
It protects the head against being hit by falling objects, hitting an obstacle
and being pressed. It is only intended for professional use and rescue. Do not
use the product for other purposes and before reading and understanding the
manual. This helmet can be safely used in the range of temperatures -30 °C
up to +50 °C. The helmet which had been exposed to a severe hit must not
be used any longer! Remember, no helmet can protect the user against all
possible dangers!
PART DESCRIPTION (Fig. 1)
A shell
B headlamp clips
C slot for the earmuffs and accessories
D slot for a protective shield
E sizing mechanism
F buckle
G chin strap
H body of the headband
I removable padding
SAFETY CHECK
Check the condition of the whole helmet before each use! In case the condition
of the helmet is not good or you are not sure about the helmet's good
condition, do not use it.
HELMET ADJUSTMENT
(fig. 2) Adjust the height of the helmet by positioning the liner in the front part.
The height can be adjusted in three steps.
(fig. 3) Use the knob to loosen the helmet before putting it on. After you put the
helmet on, tighten the mechanism so that the helmet fits your head properly.
(fig. 4) Adjust the length of the chin strap so that it so that it holds the helmet
securely. Only use the helmet in the ideal position. Only then does it provide
maximum security. If the helmet cannot be fitted securely to your head, it must
not be used.
ACCESSORIES
(Fig. 5) Adjust the length of the headlamp strap properly. Pull the strap
between the shell and the clips enough for the headlamp to stay firmly and
safely attached to the helmet.
(Fig. 6) The accessories compatible with the universal slot can be attached to
the sides of the helmet. To remove the accessories unblock the safety lock.
TRANSPORTATION AND STORAGE
(Fig. 7) WARNING! This helmet can be damaged by the solvent-based
chemicals and the chemicals containing solvents (adhesives, paints). Do not
expose the helmet to direct heat sources or long-term sunshine. Transport the
helmet in the attached cover or another textile cover of a similar kind in a dark,
dry place without weighting it with any other objects.
MAINTENANCE (Fig. 7)
Use only clear water and soft textile to desinfection and clean the helmet. Dry
the helmet in dry, well ventilated area. The inner padding can be removed
from the helmet and washed in the washing machine up to 30 °C.
If the above instructions are followed, the product can be used for 10 years
since the date of production. However mechanical damage can occur earlier.
In this case, do not use the product.
This helmet can not be modfied or repaired outside of producer's factory.
1