Hollyland Solidcom C1 Pro Hub Manual Del Usuario página 19

Operation Guide
M & R Mode Settings
After connecting two hubs using a network cable, select M & R on the hubs to set
the hub mode. On one hub, select Master Device. On the other hub, select Remote
Device > Scan and then select the IP address of the corresponding master hub.
Note that the function of obtaining the IP address automatically under Network >
Wired Network Setting needs to be turned OFF on both two hubs.
Hub Display
Select Network > Wired Network
Hub ①
Setting > OFF .
Wired Network Setting
ON
OFF
Network
IP Address:
Settings
Subnet Mask:
Gateway:
User Name:
Password:
Select Network > Wired Network
Hub ②
Setting > OFF .
Wired Network Setting
ON
OFF
Network
IP Address:
Settings
Subnet Mask:
Gateway:
User Name:
Password:
After Scan is selected, the IP
addresses of master devices will
be displayed. Then, select the
desired IP address using the
arrow buttons and press the
Menu/Confirmation button to
confirm the IP address.
192.168.218.10
Modify
255.255.255.0
Modify
192.168.218.1
Modify
admin
12345678
192.168.218.10
Modify
255.255.255.0
Modify
192.168.218.1
Modify
admin
12345678
EN-18
Select M & R > Master Device.
Master And Remote
Master Device
Remote Device
Select M & R > Remote Device >
Scan.
Master And Remote
Master Device
Remote Device
Scan
Master-Remote Device
Master 1 IP: 192.168.218.011
Master 2 IP: 192.168.218.012
Master 3 IP: 192.168.218.013
Master 4 IP: 192.168.218.014
Master 5 IP: 192.168.218.015