Publicidad
Idiomas disponibles
Idiomas disponibles
This product comes equipped with a polarized electrical plug (one blade is
wider than the other) and will only fit into the outlet one way. This is meant
to reduce the risk of an electrical shock. If the plug does not fit into the outlet,
reverse the plug. If it still does not fit, consult a qualified electrician. DO NOT
ATTEMPT TO MODIFY THIS PLUG OR CIRCUMVENT THIS SAFETY FEATURE.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment Generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
INSTRUCTIONS FOR USE
1. Ensure the PVC heating pad is fully inserted in the fabric cover and lays
completely flat. The electrical cord and controller should always remain
outside of the cover.
WARNING: ALWAYS USE THIS FABRIC COVER WHILE OPERATING THE
HEATING PAD OR SERIOUS BURNS/INJURIES MAY OCCUR.
2. Insert the plug into an appropriate 120 volt AC electrical outlet, noting the
plug is polarized and will only fit one way.
3. Place the heating pad on the desired treatment area.
WARNING: THE PAD SHOULD ALWAYS BE PLACED ON TOP OF THE
TREATMENT AREA. DO NOT PLACE PAD UNDERNEATH TREATMENT AREA
AS TEMPERATURES CAN RISE TO UNINTENDED/UNCOMFORTABLE LEVELS.
4. To turn on, use the controller to click and hold the button for 3 seconds
until the numbered light turns on. Continue to click the button to reach
the desired heat setting (1,2,3 or 4). To turn the heating pad off, click and
hold the button for 3 seconds until the number light turns off. Pay close
attention to the heat level during use and adjust the setting as needed.
5. The heating pad will reach the desired temperature in approximately 9-15
minutes.
NOTE: This heating pad will automatically turn OFF after 2 hours of use. Unplug
heating pad when not in use.
POLARIZED PLUG
FCC STATEMENT AND
EMC COMPATIBILITY
FOR DRY HEAT
3
Publicidad
