Installation Advice - CDA HCG301 Manual De Uso

Installation advice

6
6
IMPORTANT
– The appliance should be installed, regulated and adapted to
function with other types of gas by a QUALIFIED INSTAL-
LATION TECHNICIAN.
Failure to comply with this condition will render the guaran-
tee invalid.
– The appliance must be installed in compliance with regula-
tions in force.
– Installation technicians must comply to current laws in force
concerning ventilation and the evacuation of exhaust gases.
– Always unplug the appliance before carrying out any main-
tenance operations or repairs.
Fig. 6.1a
TECHNICAL INFORMATION FOR THE INSTALLER
Before installing the cooktop, remove the protective film.
This cooktop can be built into a working surface 20 to 40 mm thick and 600 mm
deep.
In order to install the cooker top into the kitchen fixture, a hole with the dimensions
shown in figs. 6.1a - 6.1b has to be made, keeping in consideration the following:
– within the fixture, between the bottom side of the cooker top and the upper sur-
face of any other appliance or internal shelf there must be a clearance of at least
30 mm;
– the cooker top must be kept no less than 100 mm away from any side wall;
– the cooker top must be kept at a distance of no less than 50 mm from the rear
wall.
– there must be a distance of at least 650 mm between the hob and any wall cup-
board or extractor hood positioned immediately above (see fig. 6.2)
– the coatings of the walls of the unit or appliances near the cooktop must be heat
resistant ("Y" protection against heating in compliance with standards EN
60335-2-6).
Do not instal the appliance near inflammable materials (eg. curtains).
INSTALLATION
The appliance must be housed in heat-resistant units.
These tops are designed to be embedded into kitchen
fixtures measuring 600 mm in depth.
The walls of the units must not be higher than work top
and must be capable of resisting temperatures of 75
°C above room temperature.
Do not instal the appliance near inflammable materials
(eg. curtains).
GAS COOKING HOBS
Fig. 6.1b
Fig. 6.2
31