GE JX9153 Instrucciones De Instalación página 3

1 LOCATE AND INSTALL THE BASE PAN
Set Base Pan into the front cabinet microwave oven
cutout and center it right and left. Push back until the
front flange is against the cabinet front wall. Mount
the Base Pan using 3 short screws.
Short
Screw
2 INSTALL THE RAILS
Disconnect the microwave oven from the receptacle.
Remove everything out of the microwave oven, including
packing, Owner's Manuals, turntable and turntable support.
A protective film has been applied to some microwave
oven and trim kits. If applied, remove the film. Turn over the
microwave oven and secure the rails to oven Base Plate
by inserting 4 short screws. Be careful not to scratch the
microwave oven.
Microwave
Oven Bottom
Rail
Short
Screw
Flanges
Installation Instructions
Base Pan
Mounting Holes
Door
3 INSTALL THE REAR DUCT
1. Gently return microwave oven to its upright position.
2. Remove screw A.
Screw A
3. Align the rear duct with the back of microwave oven, as
shown.
4. Slide 2 tabs into the slots on the right side of the back of
microwave oven.
A
5. Use 2 short screws to secure top of rear duct to the back
of microwave oven, as shown.
A
A. Short screws (2)
B. Rear duct
C. Back of microwave oven
3
B
A. Rear duct tabs
B. Slots
B C