Descargar Imprimir esta página
GE JX9153 Instrucciones De Instalación
GE JX9153 Instrucciones De Instalación

GE JX9153 Instrucciones De Instalación

Kits de horno microondas con terminaciones incorporadas
Ocultar thumbs Ver también para JX9153:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation
Instructions
Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
Save these instructions
for local inspector's use.
IMPORTANT
Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these instructions with
the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1 to 3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
• This kit is for use on models:PEB9159DJ, PEB9159SJ,
PEB9159EJ and CEB1599SJ.
• This kit and microwave are approved for installation alone
or above any single electric wall oven. Do not mount
adjacent (within 2 feet) to any range, cooktop, gas oven, or
other microwave.
• This product is to be installed 3 feet above floor level.
• Do not alter or modify any part of this kit or the oven.
• For easier installation and personal safety, we
recommend that two people install this microwave oven.
• Unplug the microwave oven before attempting installation
of this kit.
WARNING
This oven must be plugged into a
properly grounded 3-hole, 120 volt receptacle as required by
the National Electrical Code.
WARNING
Before beginning the installation,
switch power off at service panel and lock the service
disconnecting means to prevent power from being switched
on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Microwave Oven
Built-In Trim Kits
JX9152 and JX9153
PARTS INCLUDED
PART
NOTE: This kit has extra screws to prevent the technician
from spending extra time locating a replacement in case
they lose one during installation.
1
QUANITY
Rear Duct
1
Bottom Duct
1
Trim Kit
1
Frame
Rail
2
16 required
Short Screws
3 extra
Long Wood
Screws
4 required
2 extra

Publicidad

loading

Resumen de contenidos para GE JX9153

  • Página 1 Installation Microwave Oven Built-In Trim Kits Instructions JX9152 and JX9153 Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: GEAppliances.com BEFORE YOU BEGIN PARTS INCLUDED Read these instructions completely and carefully. IMPORTANT • Save these instructions PART QUANITY for local inspector’s use.
  • Página 2 Installation Instructions TOOLS YOU WILL NEED GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk ❒ 2 Phillips Screwdrivers (#1 & #2) of electric shock by providing an escape wire for the electric current.
  • Página 3 Installation Instructions 3 INSTALL THE REAR DUCT 1 LOCATE AND INSTALL THE BASE PAN 1. Gently return microwave oven to its upright position. Set Base Pan into the front cabinet microwave oven 2. Remove screw A. cutout and center it right and left. Push back until the front flange is against the cabinet front wall.
  • Página 4 Installation Instructions 3 INSTALL THE REAR DUCT (continued) 6 SECURE THE RAILS TO THE CABINET 6. Use 3 short screws to secure back of rear duct to the Ensure the Base Pan and Bottom Bracket front flanges are back of microwave oven, as shown. tight against the cabinet, and that the screws holes are aligned.
  • Página 5 Instrucciones Kits de Horno Microondas con Terminaciones Incorporadas de Instalación JX9152 y JX9153 ¿Preguntas? Llame a 800.GE.CARES (800.432.2737) o Visite nuestro sitio web en: GEAppliances.com ❒ ANTES DE COMENZAR PIEZAS INCLUIDAS Lea estas instrucciones en su totalidad y atentamente. IMPORTANTE •...
  • Página 6 Instrucciones de Instalación HERRAMIENTAS QUE NECESITARÁ INSTRUCCIONES DE CONEXIÓN A TIERRA Este electrodoméstico deberá estar conectado a tierra. En ❒ 2 Destornilladores Phillips (nº 1 y nº 2)) caso de que se produzca un cortocircuito, la conexión a tierra reduce el riesgo de descarga eléctrica, brindando un cable de ❒...
  • Página 7 Instrucciones de Instalación 3 INSTALACIÓN DEL CONDUCTO 1 UBIQUE E INSTALE UNA OLLA DE LA TRASERO BASE 1. De forma suave gire el horno microondas hasta su posición Coloque la Olla de la Base en la abertura del gabinete vertical. frontal del horno microondas y centre la misma sobre 2.
  • Página 8 No los coloque en el horno microondas. 3. Reemplace el fusible del hogar o cierre el disyuntor para reiniciar la corriente en el panel del servicio. DE68-03364A 49-40762-1 LEA DETENIDAMENTE. CONSERVE ESTAS INSTRUCCIONES. 08-16 GE Impreso en China...

Este manual también es adecuado para:

Jx9152Jx9153sjssJx9153djwwJx9152sjssJx9152djbbJx9152djww