Publicidad
Idiomas disponibles
Idiomas disponibles
D H
4 5 1 5
Keep Working
Iinserting(see figure A)
Clean and lightly grease the shank end of the tool.
Whirligig the stop pin to 180°and insert the tool in a twisting manner into the tool holder. Release the locking sleeve 1 again in
order to lock the tool.
Check the latching by pulling the tool.
FIGURE B
Removing(see figure B)
Whirligig the stop pin to 180° and remove the tool.
STARTING OPERATION
Observe correct mains voltage! The voltage of the power source must agree with the voltage specified on the type plate of the
power tool.
Switching ON and off
To start the power tool, press the on/off switch 6 and keep it pressed.
To lock the pressed on/off switch 6,push the lock-on button 4 upward.
Sharpening chisels
Good results are only achieved with sharp chisele; therefore, sharpen the chiseling tools in good time. This ensures a long service
life the tools and good working performance.
KEEP WORKiNG
10
Publicidad
