Elite AG1420 Manual De Usuario página 19

Mounting the guard
Disc and side handle
Before mounting the disc guard and side handle, remove the disc, if any, and follow the instructions listed below, considering
figure A.
Fig A
On and off
WARNING
Before plugging the tool, verify that the switch is in the off mode. Check the type of switch your machine has (slide or trigger
with safety lock) and follow the instructions for your model.
Slide switch
To turn on your grinder, slide the drive switch forward.
To turn off your tool, simply slide the drive switch back. Trigger switch with safety lock to turn on your grinder, first press
the safety lock and then pull the trigger.
To turn off your tool, simply release the drive switch.
Use tips
WARNING
To avoid injury, never use the abrasive disc without the guard in place.
Hold your angle grinder firmly with one hand around the side handle and the other around the machine body, so you have
complete control at all times. The starting torque creates sudden vibration.
Always position the guard so that anything that may come off the disc points away from you. After starting the machine,
apply the abrasive disc to the workpiece.
KEEP WORKiNG KEEP WORKiNG
Keep Working Keep Working
Fig B
14 01
a g 1 4 2 0